MCQ on Thermodynamics

Category: Thermodynamics

Post Published On:

4 min read

1-If ‘n’ is the index of compression, then the work done in compressing air is proportional to
(A) n
(B) n2
(C) (n / n-1)
(D) (n-1 / n)
 
2-For the same compression ratio
(A) Otto cycle is more efficient than Diesel cycle
(B) Diesel cycle is more efficient than Otto cycle
(C) The efficiency of Otto and Diesel cycle are same
(D) None of the above
 
3-Reheating in gas turbine is done
(A) between compressor stages
(B) between turbine stages
(C) between compressor and turbine
(D) with combustion chamber
 
4-Intercooling in compressors is meant for
(A) reducing the work of compression
(B) increasing the compressor efficiency
(C) reducing the power input
(D) all of the above
 
5-Compression ratio is the ratio between
(A) total volume and clearance volume
(B) total volume and swept volume
(C) maximum pressure and minimum pressure
(D) delivery pressure and suction pressure
 
6-The following cycle provides the maximum work output between two temperature inputs
(A) Otto cycle
(B) Diesel cycle
(C) Brayton cycle
(D) Carnot cycle
 
7-The first law of thermodynamics deals with
(A) Conservation of mass
(B) Conservation of enthalpy
(C) Conservation of energy
(D) Conservation of momentum
 
8-The quantity H-TS is termed as
(A) Flow work
(B) Gibbs function
(C) Helmholtz function
(D) excergy
 
9-The work done in a constant volume process is
(A) Very high
(B) Very low
(C) Moderate
(D) Zero
 
10-In a process PVn=C, If n=1, then the process is
(A) Constant pressure
(B) Constant temperature
(C) Constant volume
(D) Constant entropy
 
11-A thermodynamic system which permits only energy transfer through its boundaries is a (an)
(A) open system
(B) closed system
(C) isolated system
(D) rigid system
 
12-The Carnot cycle consists of
(A) Two constant volume process
(B) Two constant pressure process
(C) Two isenthalpic process
(D) Two isothermal process
 
13-The property of a system whose value does not depend upon the mass of the system is known as
(A) Intensive property
(B) Extensive property
(C) Constant property
(D) Variable property
 
14-Ideal ‘operating characteristics curve’ looks like
(A) Triangle
(B) Circle
(C) Rectangle
(D) Square
 
15-Which of the following defines the ideal gas equation?
Where p=absolute pressure, v=specific volume, T=absolute temperature and R=Gas constant
(A) pv=RT
(B) pR=vT
(C) pT=vR
(D) p=v/RT
 
16-Internal energy of an isolated system
(A) increases with addition of heat
(B) increases with increase in mass of the system
(C) remain same
(D) increases with addition of work
 
17-Which is a single phase system?
(A) Mixture of water and alcohol
(B) Mixture of oil and water
(C) Liquid water, ice and water vapour
(D) Water and ice
 
18-ITS-90 defines which of the following as a reference for calibration of temperature scale
(A) Ice point
(B) Lamda point
(C) Normal boiling point of water
(D) Triple point of water
 
19-Pressure of the atmosphere is equivalent to
(A) 0.101325 MPa
(B) 750 mm of mercury
(C) 1 bar
(D) 0.101325 KPa
 
20-Attemperation is done
(A) Just after the secondary superheater
(B) Just before the primary superheater
(C) Between the primary and secondary superheater
(D) At the entry of steam from boiler
 
21-The air standard cycle with the following processes in sequence: 1. Reversible adiabatic compression, 2. Reversible constant pressure heat addition, 3. Reversible adiabatic expansion and, 4. Reversible constant volume heat rejection, is
(A) Otto cycle
(B) Diesel cycle
(C) Dual cycle
(D) Brayton cycle
 
22-In convergent divergent nozzle, normal shock can generally occur:
(A) Along the divergent portion and throat
(B) Along the convergent portion
(C) Anywhere along the length
(D) Near the inlet
 
23-Isenropic flow is
(A) Irreversible adiabatic flow
(B) Reversible adiabatic flow
(C) Ideal fluid flow
(D) Frictionless reversible flow
 
24-An aeroplane is cruising at a speed of 800kmph at an altitude, where the air temperature is zero degree Celsius. The flight Mach number at this speed is nearly
(A) 1.5
(B) 0.254
(C) 0.67
(D) 2.04
 
25-An IC engine has a bore and stroke of 2 units each. The area to calculate heat loss can be taken as
(A) 4π
(B) 5π
(C) 6π
(D) 8π
 
26-With increasing temperature of intake air, IC engine efficiency
(A) Decreases
(B) Increases
(C) Remains the same
(D) Depends on other factor
 
ANSWERS:
1-(C), 2-(A), 3-(B), 4-(D), 5-(A), 6-(D), 7-(C), 8-(B), 9-(D), 10-(B), 11-(B), 12-(D), 13-(B), 14-(C), 15-(A), 16-(C), 17-(A), 18-(D), 19-(A), 20-(C), 21-(B), 22-(A), 23-(B), 24-(C), 25-(D), 26-(A)

zusammenhängende Posts

Android 15: Nachrichten und erwarteter Preis (kostenlos), Erscheinungsdatum, Funktionen und andere Gerüchte

Google Pixel 9: Nachrichten und erwarteter Preis, Veröffentlichungsdatum, Spezifikationen; und weitere Gerüchte

Samsung bringt 2 neue USB-Flash-Laufwerke mit je 512 GB auf den Markt.

Stichworte

Kommentare

Leave a Comment

Über uns

Anuragcareer

Anuragcareer hat nur ein Ziel: über alles zu berichten, was mit Technologie in unserem Leben zu tun hat.

Wir teilen nützliche, informative und unterhaltsame Informationen für Sie alle auf Deutsch.

Beliebte Beiträge

Android 15: Nachrichten und erwarteter Preis (kostenlos), Erscheinungsdatum, Funktionen und andere Gerüchte

Google Pixel 9: Nachrichten und erwarteter Preis, Veröffentlichungsdatum, Spezifikationen; und weitere Gerüchte

Samsung bringt 2 neue USB-Flash-Laufwerke mit je 512 GB auf den Markt.

Mit dem neuen Apple-Reparaturprogramm können einige gebrauchte Teile verbessert werden

Wichtige Seiten

Über uns

Kontaktiere uns

DMCA

Privacy Policy

Terms & Conditions

Phone: +17864540015
Email: contact@www.anuragcareer.com

Don`t copy text!